Gateway 955 - Manual (Page 17)

11
Mounting your server into a cabinet
www.gateway.com
Mounting your server into a
cabinet
The cabinet mounting hardware included with your server should be used with
standard 4-post cabinets that have front and back vertical posts. The L-shaped
cabinet mounting brackets can be used for mid-mounting on a 2-post cabinet,
but that procedure is not covered here. If your cabinet is a different type, obtain
mounting hardware from the cabinet manufacturer.
Rackmount kit contents:
■ Server rails (2)
■ Cabinet rails (2)
■ L brackets (2, not used for this type of installation)
■ Fastener pack (1)
■ Small screws (4, #6-32 × 3/16-inch)
■ Medium screws (8, #10-32 × ½-inch)
■ Large screws (2, #10-32 × 7/8-inch)
■ Handle spacers (2)
■ Nut bars (4)
■ Disk guides (2)
Warning Before attaching cabinet accessories, make sure that
the server is turned off and all power cords are
unplugged.
Warning The cabinet must provide sufficient airflow to the front
of the server to maintain proper cooling. It must also
include ventilation sufficient to exhaust a maximum of
1200 BTUs per hour for this server.