Battery replacement, Beep codes, Battery replacement beep codes – Gateway 955 User Manual
Page 109
103
Troubleshooting
www.gateway.com
Battery replacement
If you have problems after installing a new CMOS battery, try each of the
following items, closing the case and restarting the server after each try:
■
Restart your server, then open the BIOS Setup utility by pressing and
holding F2 while your server restarts. Correct any discrepancies.
■
Remove the top panel by following the instructions in
, then make sure that all cables inside the case are attached
securely. Also, make sure that the colored cable edges are aligned correctly
and that the connectors do not miss any pins.
■
If you have the correct test equipment, make sure that the new battery
has power. Although unlikely, your new battery may be defective.
Beep codes
Whenever a recoverable error occurs during the power-on self-test (POST), the
BIOS displays an error message that describes the problem. The BIOS also sounds
a beep code for errors when video is not available for text messages.
A PCI expansion card (for example, a RAID controller) can also issue audible
errors by itself, usually consisting of one long tone followed by a series of short
tones. For more information on the beep codes issued, check the
documentation for that device.
Warning
To avoid bodily injury, do not attempt to troubleshoot your
server problem if:
■
The power cord or plug is damaged
■
Liquid has been spilled into your server
■
Your server was dropped
■
The case was damaged
Instead, unplug your server and contact a qualified
computer technician.