Gateway ADAC ULTRA2 S466 - Manual (Page 84)

ADAC Ultra2 S466 Hardware Guide 70
Step 11 Run ADAC BIOS Setup
Press to run the ADAC BIOS Setup utility.
See the ADAC Ultra2 S466 Configuration Software Guide
for information about running BIOS Setup.
Step 12 Install Operating System Driver
The ADAC Ultra2 S466 ASPI driver can be used in the
DOS and Windows 95 environments. The DOS ASPI
driver supports:
•
up to six non-disk SCSI devices (each SCSI device
must use a unique SCSI ID regardless of the SCSI
channel it resides on. SCSI IDs 1 through 6 are valid,
•
up to 12 ADAC Ultra2 S466 adapters, and
•
virtual DMA services (VDS) for up to eight logical
drives.
ASPI Driver CorelSCSI, Novaback, and PC Tools are not provided with
ADAC Ultra2 S466.
Drivers Devices Supported Application Software Features
ADACASPI .SYS CD-ROM, tape,
optical drives, etc. CorelSCSI, Novaback, PC
Tools. VDS
Copy ADACASPI.SYS to your hard disk drive. Add the
following line to CONFIG.SYS:
device= \ADACASPI.SYS /v
Parameters The ADACASPI.SYS parameters are:
Parameter Description
/h INT 13h support is not provided.
/v Verbose mode. All message are displayed on the screen.
/a Physical drive ccess mode. Direct access to physical drives is
permitted.
/q Quiet mode. All message except error message are suppressed.
Cont’d