Step 5 set jumpers – Gateway ADAC ULTRA2 S466 User Manual

Page 74

ADAC Ultra2 S466 Hardware Guide

Step 5 Set Jumpers,

Continued

J8, J9

J8 and J9 are 3-pin jumpers. The factory setting is Pins 1-2
shorted. Pins 1-2 should always be shorted for J8 and J9.

J10

J10 is a 3-pin jumper. Make sure Pins 1-2 of J10 are
always shorted. This is the factory setting.

J11, J12 i960RP Initialization J11 and J12 are 2-pin bergs that specify the

i960RP mode when initially powered up. Mode 3 is used
for normal operation (J11 and J12 OPEN). All other modes
are used for test purposes only.

I960RP Initialization Mode

J19 Setting

J22 Setting

Short Pins 1-2

OPEN

Short Pins 1-2

OPEN