Gateway ADAC ULTRA2 S466 - Manual (Page 13)

Preface xiii
FCC Regulatory Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority
to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a specific installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, try to correct the interference by one or
more of the following measures:
1) Reorient or relocate the receiving antenna.
2) Increase the separation between the equipment and
the receiver.
3) Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
4) Consult the dealer or an experienced radio/TV technician
for help.
Shielded interface cables must be used with this product to ensure
compliance with the Class B FCC limits.
Gateway ADAC Ultra2 S466 PCI RAID Controller
Model Number: Series 466
FCC ID Number: IUESER466