Gateway 7400 - Manual (Page 71)

Expansion cards 63
Expansion cards
The server has seven PCI expansion slots on the system board, that may be
used for a variety of expansion cards. Two of these slots support 64-bit PCI
cards and five support 32-bit PCI cards. (See “System board” on page 8.)
Replacing an expansion card
To replace an expansion card:
1 Set any jumpers and switches on the replacement card. (See the card
instructions.)
2 Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
3 Observe all safety and static electricity precautions. (See “Preventing static
electricity discharge” on page 22.)
4 Remove the bezel. (See “Removing the bezel” on page 25.)
5 Remove the left side cover panel. (See “Removing the side cover panel”
on page 26.)
6 Disconnect any cables attached to the card.
8508366.book Page 63 Tuesday, October 23, 2001 11:29 AM