Gateway 7400 - Manual (Page 51)

Drives 43
Removing an empty drive carrier
If the system ships with less than six drives installed, the empty drive bays
contain drive carriers.
If you need to replace an empty drive carrier in the system, make sure it slides
straight into place until the plastic handle begins to move upward, then close
the handle.
To remove an empty drive carrier:
1 If the drive carrier is locked, use the hex key to unlock the carrier. Locked
drive carriers show a red flag in the slot on the carrier handle.
2 Remove the drive carrier from the drive bay by pressing down on the
carrier handle and rotating the handle out and down from the front of
the server.
8508366.book Page 43 Tuesday, October 23, 2001 11:29 AM