Gateway 7400 - Manual (Page 61)

Replacing or adding memory 53
To add DIMMs:
1 Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
2 Observe all safety and static electricity precautions. (See “Preventing static
electricity discharge” on page 22.)
3 Remove the bezel. (See “Removing the bezel” on page 25.)
4 Remove the left side cover panel. (See “Removing the side cover panel”
on page 26.)
5 Pull open the socket latches on each side of the DIMM socket.
6 Insert the new DIMM into the socket and align the two notches in the
DIMM with the two notches in the DIMM socket.
7 Gently press the DIMM into the socket until it is firmly seated. Inserting
the DIMM automatically locks the socket latches on each end of the
DIMM.
8 Replace the bezel. (See “Replacing the bezel” on page 28.)
8508366.book Page 53 Tuesday, October 23, 2001 11:29 AM