FUJITSU C150-E049-02EN - Manual (Page 182)

M3099GX/GH OEM Manual 5-3
ERROR
PROCESSING
AND RECOVERY
Table 5.1 Device and operator actions for temporary errors (continued)
Scanner actions Action to recover LCD display
COVER
OPEN
MISS
PICK
ROLLER
UNIT
NOT SET
HOPPER
OVER-
LOAD
- The mechanism system is
stopped immediately and
an error message is
displayed
on the LCD display.
- If the scanner is not
working, “Temporary
Error” is returned when a
SENSE, START, or
READ command is
received.
- The hopper table is
lowered to the bottom.
- When an error is detected, the
magnetic clutch (pick clutch)
is turned off and the normally
scan document is ejected to
the stacker.
Then, the mechanism system
is stopped.
- “Temporary Error” is returned
to the host computer and an
error message is displayed on
the LCD display.
- The hopper table is
lowered to the bottom.
- The ADF roller ASY is not
mounted correctly.
- The documents loaded on
the ADF exceed the
specified number of pages.
- Close the upper
transport unit or the
endorser cover.
- Or turn the thumb
screw to lock the
back-side lamp unit.
- Open the upper
transport unit and
remove the document
on the transport path.
Then, close the unit.
- Return the jammed
document on the
hopper and read it
again.
- Open the upper
transport unit and
correct the roller unit
setting, then close the
upper transport unit.
See chapter␣ 4, “Roller
ASY Replacement”.
- Remove the document
to the specified number
of sheets.
#05 Chapter 5 98.2.22, 1:51 PM 3