FUJITSU C150-E049-02EN - Manual (Page 107)

3-74 M3099GX/GH OEM Manual
Unload Object : This position function specifies that the object shall
be positioned for removal. If upon receipt of this command there is
no object loaded, the target shall return a GOOD status. This
condition shall not be considered as an error. If the target is unable
to unload the object (i.e. paper jam or mis-feeding condition), the
target shall return CHECK CONDITION status and set the sense
key sense to MEDIUM ERROR.
Load Object : The position function specifies that the object is to be
loaded and positioned to the base line. If upon receipt of this
command there is a object already loaded, the target shall returns
GOOD status. This condition shall not be considered as an error. If
an object is not loaded and the target is unable to load an object, the
target shall return CHECK CONDITION status and set the EOM
bit to one and the sense key to MEDIUM ERROR.
Count : 000000h(Reserved)
SEND Command
The SEND command (Table 3.56) transfers data from the initiator
to the target.
Table 3.56 SEND Command
Bit
Byte
0
1
2
3
4
5
6
7
8
9
7 6 5 3 2 1 0
Operation Code (2Ah)
Data Type Code
Reserved
Data Type Qualifier
Transfer Length
Control
Logical Unit Number Reserved
4
(MSB)
(MSB)
(LSB)
(LSB)
#03.pm5 98.2.22, 1:33 PM 74