FUJITSU C150-E049-02EN - Manual (Page 130)

M3099GX/GH OEM Manual 3-97
INTERFACE
Status (See ANSI
SCSI-2 7.3) The status byte and status byte code are defined in Table 3.80, 3.81.
A status byte shall be sent from the target to the initiator during the
STATUS phase at the completion of each command unless the
command is terminated by one of the following events:
a) an ABORT message;
b) an ABORT TAG message; (ABORT TAG is not supported by
this scanner)
c) a BUS DEVICE RESET message;
d) a CLEAR QUEUE message;(CLEAR QUEUE is not supported
by this scanner)
e) a hard reset condition;
f) an unexpected disconnect.
The STATUS phase normally occurs at the end of a command but
in some case may occur prior to transferring the command descriptor
block.
Table 3.80 Status Byte
Bit 7 6 5 0
Reserved Status Byte Code Reserved
3 2 1 4
Table 3.81 Status Byte Code
Bits of Status Byte
7
R
R
R
R
R
R
R
R
R Supported
Supported
Supported
Supported
Status
GOOD
CHECK CONDITION
CONDITION MET
BUSY
INTERMEDIATE
INTERMEDIATE-CONDITION MET
RESERVATION CONFLICT
COMMAND TERMINATED
QUEUE FULL
Reserved
6
R
R
R
R
R
R
R
R
R
5
0
0
0
0
0
0
0
1
1
4
0
0
0
0
1
1
1
0
0
3
0
0
0
1
0
0
1
0
1
2
0
0
1
0
0
1
0
0
0
1
0
1
0
0
0
0
0
1
0
0
R
R
R
R
R
R
R
R
R
All Other Code
Key: R = Reserved bit
#03.pm5 98.2.22, 1:33 PM 97