Controlling the resin heat – FARGO electronic S000256 User Manual

Page 90

Text mode
Original mode

RESTRICTED USE ONLY

FARGO Electronics, Inc.

Controlling the Resin Heat

Step Procedure

Control the amount of heat the Printer uses when printing with the resin black
panel(s) of a full-color ribbon or when printing with a resin-only ribbon by
adjusting the Resin Heat.

Note #1: This control can be helpful for fine-tuning the saturation of resin text
and bar codes.) Adjust the Resin Heat (K) setting (as needed), as shown below.

Note #2: This option only effects objects printed with a resin-only print ribbon or
those objects printed on the back side of a card with the resin black panel of a
YMCKO, YMCKOK, or YMCKK print ribbon.

Note #3: Use this option to control the amount of heat the Printer uses when
printing with the resin black panel(s) of a full-color ribbon or when printing with a
resin-only ribbon, adjust the Resin Heat slide.

Persona

® C25 Card Printer User Guide (Rev. 4.0)