beautypg.com

Cleaning the card feed rollers (continued) – FARGO electronic S000256 User Manual

Page 134

background image

RESTRICTED USE ONLY

FARGO Electronics, Inc.

Cleaning the Card Feed Rollers (continued)

Step Procedure

4

a. Insert the Cleaning Card into the Card Hopper, above the Card Input Tray,

as normally done with any other type of card.

b. Be sure, however, that the shortest non-adhesive end of the Cleaning

Card enters the Printer first and that the sticky side is facing UPWARD.

Caution: If the card is inserted with the sticky side facing downward,

it will stick to the Card Input Tray and will not feed.

5

Once the Cleaning Card is properly inserted into the Card Hopper, hold down
the On/Cancel button and push the Cleaning Card into the Printer until the
second gray feed Roller grabs and begins feeding the card.

6

a. Continue to hold down the On/Cancel button until the Cleaning Card has

fed completely through the Printer.

b. Repeat this cleaning procedure as needed.

c. After the cleaning procedure is finished, re-install media, close the

Printer's Top Cover, and turn the Printer power OFF and ON to reset the
Printer.

7

Be sure to use either clear tape or masking tape. (Note: If the cleaning kit is
not available, adhesive tape is also an effective method for removing lint and
debris from the Rollers.)

Caution: Do not use duct or strapping tape. These adhesives leave

a gummy residue behind.

8

a. Open the lid, and use the Pause/Resume and On/Cancel buttons to

rotate the main feed Rollers, while applying the tape.

b. Alternatively, use 99% pure alcohol wipe. Do not use these wipes for

every cleaning because this could eventually deplete the tact from the
Roller’s rubber.

(Warning: Do not use alcohol to clean the Cleaning Roller Assembly.)

Persona

® C25 Card Printer User Guide (Rev. 4.0)

134