beautypg.com

Section 2: general troubleshooting, Safety messages (review carefully) – FARGO electronic S000256 User Manual

Page 22

background image

RESTRICTED USE ONLY

FARGO Electronics, Inc.

Section 2: General Troubleshooting

The purpose of this section is to provide the User with specific procedures relating to the
LCD/SmartGuard Messages, Communication Errors, Card Feeding Errors, Print Process
Errors, Card Jam Errors, Ribbon Errors, Encoding Errors, Diagnosing Image Problem,
Running the Self-Test, and Interfacing Information for the Persona C25 Card Printer.

Safety Messages (review carefully)

Symbol

Critical Instructions for Safety purposes

Danger:

Failure to follow these installation guidelines can result in death or
serious injury.

Information that raises potential safety issues is indicated by a warning
symbol (as shown to the below).

To prevent personal injury, refer to the following safety messages

before performing an operation preceded by this symbol.

To prevent personal injury, always remove the power cord prior to

performing repair procedures, unless otherwise specified.

To prevent personal injury, make sure only qualified personnel

perform these procedures.

Caution:

This device is electrostatically sensitive. It may be damaged if
exposed to static electricity discharges.

Information that raises potential electrostatic safety issues is indicated
by a warning symbol (as shown to the below).

To prevent equipment or media damage, refer to the following

safety messages before performing an operation preceded by this
symbol.

To prevent equipment or media damage, observe all established

Electrostatic Discharge (ESD) procedures while handling cables in
or near the Circuit Board and Printhead Assemblies.

To prevent equipment or media damage, always wear an

appropriate personal grounding device (e.g., a high quality wrist
strap grounded to avoid potential damage).

To prevent equipment or media damage, always remove the

Ribbon and Cards from the Printer before making any repairs,
unless otherwise specified.

To prevent equipment or media damage, take jewelry off of

fingers and hands, as well as thoroughly clean hands to remove oil
and debris before working on the Printer.

Persona

® C25 Card Printer User Guide (Rev. 4.0)

22