FARGO electronic S000256 - Manual (Page 35)

RESTRICTED USE ONLY FARGO Electronics, Inc.
Resolving the Card Feeding Errors (continued)
Step Procedure
2 Ensure the Card Separator Flap is set correctly
a. Loosen the two screws on either side of the card width guides in the Input
Hopper. See Graphic 1.
b. Open the Top Print Cover
c. Adjust the screws on either side of the orange card separator flap to raise
or lower the separator flap to the desired height. See Graphic 2.
Persona
® C25 Card Printer User Guide (Rev. 4.0)
35