FARGO electronic S000256 - Manual (Page 65)

RESTRICTED USE ONLY FARGO Electronics, Inc.
Dye-Sub and Resin Intensity Adjustments
Reviewing the RP1 Potentiometer location (Printhead Darkness RP1
Pot)
RP1 is the baseline level control for the Printhead intensity.
Step Procedure
1 a. Turn the RP1 potentiometer counter-clockwise in 1/8 th turn increments to
increase the overall darkness level, and affect both Dye-Sub and Resin
transfer levels.
b. Turn the pot clockwise by the same amount, which causes the output to lighten
the intensity.
2 a. When the Printhead is replaced or if using another brand of blank cards, run
the self-test. See the Performing the Standard Self Test procedure on page
57.
b. Use the results of the Standard self test to make appropriate adjustments to
the RP1 potentiometer.
DARKNESS
Rp1
Rp7
OFFSET MAG
OFFSET PRN
RP3
Rp6
OFFSET LAM
Tp5
COLOR
Tp3
Persona
® C25 Card Printer User Guide (Rev. 4.0)
65