FUJITSU 2000 - Manual (Page 62)

48
• Reset Configuration Data
Normally, you leave this field Disabled. Select Enabled to reset Extended
System Configuration Data (ESCD) when you exit Setup if you have installed a
new add-on and the system reconfiguration has caused such a serious conflict
that the operating system can not boot.
The settings are: Enabled and Disabled.
• Resource Controlled By
The Award Plug and Play BIOS has the capacity to automatically configure all of
the boot and Plug and Play compatible devices. However, this capability means
absolutely nothing unless you are using a Plug and Play operating system such
as Windows ® 95/98. If you set this field to “manual” choose specific
resources by going into each of the sub menu that follows this field (a sub
menu is preceded by a “
➢”). The settings are:
Auto(ESCD), Manual.
• IRQ Resources
When resources are controlled manually, assign each system interrupt a type,
depending on the type of device using the interrupt.
• DMA Resources
This sub menu can let you control the memor y resource.
• PCI/VGA Palette Snoop
Leave this field at Disabled. The settings are Enabled, Disabled.
She_Chp2_28-52 19/1/00, 16:28 48