FUJITSU 2000 - Manual (Page 57)

43
• Onboard Parallel Mode
SPP : Standard Parallel Por t
EPP : Enhanced Parallel Port
ECP : Extended Capability Port
To operate the onboard parallel port as Standard
Parallel Port only, choose “SPP.” To operate the
onboard parallel por t in the EPP modes simultaneously,
choose “EPP.” By choosing “ECP”, the onboard parallel
port will operate in ECP mode only. Choosing “ECP +
EPP” will allow the onboard parallel port to support
both the ECP and EPP modes simultaneously. The ECP
mode has to use the DMA channel, so choose the
onboard parallel por t with the ECP feature. After
selecting it, the following message will appear: “ECP
Mode Use DMA” At this time, the user can choose
between DMA channels 3 or 1. The onboard parallel
port is EPP Spec. compliant, so after the user chooses
the onboard parallel por t with the EPP function, the
following message will be displayed on the screen:
“EPP Mode Select.” At this time either EPP 1.7 spec. or
EPP 1.9 spec. can be chosen.
SPP/EPP/ECP/
ECP+EPP
• PWRON After PWR-FAIL
This option will determine how the system will power on after a power failure.
The setting are: Former-sts (Formar states), ON and OFF
• Game Port Address/Midi Port Address
This will determine which Address the Game Por t/Midi Port will use.
• Midi Port IRK setting are IRK5 or IRK10
• Power Status LED
This item determines which state the Power LED will use. The settings are
Blinking, Dual, and Single. During blinking, the power LED will blink when the
system enters the suspend mode. When the mode is in Dual, the power LED
will change its color. Choose the single and the power LED will always remain
lit.
She_Chp2_28-52 19/1/00, 16:28 43