FUJITSU 2000 - Manual (Page 56)

42
• IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple
sector read/write. If your IDE hard drive supports block mode (most new drives
do), select Enabled for automatic detection of the optimal number of block
read/writes per sector the drive can support. The settings are: Enabled,
Disabled.
• Power On Function
This function allows you to select the item to power on the system. The
settings are : Any Key, Button Only, Mouse Left, Mouse Right, Password,
Hotkey, keyboard 98.
• Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on
the system board and you wish to use it. If you install add-on FDC or the
system has no floppy drive, select Disabled in this field.
The settings are: Enabled and Disabled.
• Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second serial
por ts. The settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3,
Disabled, Auto.
• UART Mode Select
This item allows you to determine which InfraRed(IR) function of the onboard
I/O chip, this functions uses.
• Onboard Parallel Port
Disabled There is a built-in parallel port on the on-board Super
I/O chipset that provides Standard, ECP, and EPP
features. It has the following options:
(3BCH/IRQ7)/
(278H/IRQ5)/
(378H/IRQ7)
Disable
3BCH/IRQ7 Line Printer por t 0
278H/IRQ5 Line Printer por t 2
378H/IRQ7 Line Printer por t 1
She_Chp2_28-52 19/1/00, 16:28 42