FUJITSU ServerView Virtual-IO Manager V3.1 - Manual (Page 125)

You configure the network parameters of an I/O connection blade as follows:
l
In the Remote Manager, choose (1) Management Agent – (6) Con-
nection Blade.
l
Select an I/O connection blade.
l
Choose (2) Management Port Information.
l
Make the relevant entries for the following parameters
o IP Mode Setting Value
o IP Address Setting Value
o Subnet Mask Setting Value
o Gateway Setting Value
l
Activate the settings by clicking Apply Management port Network Set-
ting.
For Fibre Channel switch modules (select FC Switch Blade),
you must also specify access data for the parameters Set
Login Username and Set Login Password beforehand for the
corresponding I/O connection blade in the management blade.
ServerView Virtual-IO Manager 125
4.3 Configurations on the managed BX900 Blade Server