FUJITSU ServerView Virtual-IO Manager V3.1 - Manual (Page 108)

4 Configuration
Example
(Vty-0) #show uplink-set
Uplink External External External Link Port IGMP
Set Name ports active ports backup ports state Backup snoop LACP
-------- -------------- ------------ ------------ ----- ------ ----- ----
default - - - yes no yes no
1_NET 0/11 0/11 - yes yes yes no
1_NW1 0/12,0/13,0/14 0/13,0/14 0/12 yes yes yes no
1_NW2 0/15,0/16 0/15 0/16 yes yes yes no
(Vty-0
(Vty-0) #show port-group
Port Group Name Internal Ports Uplink Set Name External Ports
------------------- -------------- ------------------- --------------
default - default -
1_INTERN_1 - -
1_INTERN_2 - -
1_NET 0/1,0/2 1_NET 0/11
1_NW1 - 1_NW1 0/12,0/13,0/14
1_NW2 - 1_NW2 0/15,0/16
In the above example, the first uplink port 0/11 belongs to the uplink set 1_
NET, and the port group 1_NET is assigned to this uplink set.
If port 0/11 does not belong to any uplink set, but should belong to uplink set
1_NET, then enter the following commands:
(Vty-0) #configure
(Vty-0) (Config)#interface 0/11
(Vty-0) (Interface 0/11)#uplink-set 1_NET
(Vty-0) (Interface 0/11)# exit
(Vty-0) (Config)#exit
(Vty-0) #
If the first uplink port 0/11 belongs to the uplink set 1_NET, but no port group
108 ServerView Virtual-IO Manager