FUJITSU MHK2090AT - Manual (Page 15)

Contents
x C141-E088-03EN
CHAPTER 3 Installation Conditions..............................................................3-1
3.1 Dimensions 3-2
3.2 Mounting 3-4
3.3 Cable Connections 3-9
3.3.1 Device connector 3-9
3.3.2 Cable connector specifications 3-10
3.3.3 Device connection 3-10
3.3.4 Power supply connector (CN1) 3-11
3.4 Jumper Settings 3-11
3.4.1 Location of setting jumpers 3-11
3.4.2 Factory default setting 3-12
3.4.3 Master drive-slave drive setting 3-12
3.4.4 CSEL setting 3-13
CHAPTER 4 Theory of Device Operation......................................................4-1
4.1 Outline 4-2
4.2 Subassemblies 4-2
4.2.1 Disk 4-2
4.2.2 Head 4-2
4.2.3 Spindle 4-3
4.2.4 Actuator 4-3
4.2.5 Air filter 4-3
4.3 Circuit Configuration 4-4
4.4 Power-on Sequence 4-6
4.5 Self-calibration 4-7
4.5.1 Self-calibration contents 4-7
4.5.2 Execution timing of self-calibration 4-8
4.5.3 Command processing during self-calibration 4-9
4.6 Read/write Circuit 4-9