FUJITSU MHV2160BT - Manual (Page 185)

5.3 Host Commands
C141-E239 5-109
*2 Word 1, 3, 6, 60-61
Word MHV2160BT
1 X’3FFF’
3 X’10’
6 X’3F’
60-61 X’FFFFFFF’
*3 Status of the Word 2 Identify information is shown as follows:
37C8h The device requires the SET FEATURES sub-command after the
power-on sequence in order to spin-up. The Identify information
is incomplete.
738Ch The device requires the SET FEATURES sub-command after the
power-on sequence in order to spin-up. The Identify information
is incomplete.
8C73h The device requires the SET FEATURES sub-command after the
power-on sequence in order to spin-up. The Identify information
is incomplete.
C837h The device requires the SET FEATURES sub-command after the
power-on sequence in order to spin-up. The Identify information
is incomplete.
Others Reserved
*4 Word 49: Capabilities
Bits 15-14: Reserved
Bit 13: Standby timer value. ATA spec is '1.'
Bit 12: Reserved
Bit 11: '1' = IORDY supported
Bit 10: '1' = IORDY inhibition supported
Bit 9: '1' = DMA supported
Bit 8: '1' = LBA supported
Bits 7-0: Undefined