FUJITSU Image Scanner fi-5220C - Manual (Page 21)

fi-5120C / fi-5220C Image Scanner Operator
Guide
TROUBLE SHOOTING
CONTENTS MAP
TOP
2.1Turning the Scanner ON (1)
1 2 3 4 5 6
This section describes how to turn the scanner ON.
The following shows the procedure for turning the scanner ON.
1. Press the power button on the operator panel.
The scanner is turned ON, and the green LED on the operator panel lights. Also, while the scanner is being initialized,
the indication of the Function Number display changes as follows: "8" -> "P" -> "0" -> "1" The indication "1" means
that the operator panel is in the ready status.
Power button
HINT
To turn the scanner OFF, hold the power button down for at least two seconds.
About Power ON/OFF Control
You can select to power the scanner on/off either by pressing the Power button, or by connecting / disconnecting the AC
cable.
The procedure is as follows.
1. Open Scanner's Properties.
1) When turning on the power, check that the scanner is connected to your PC.
Refer to "2.2 Connecting the Scanner to a PC in " fi-5120C / fi-5220C Getting Started".
1 2 3 4 5 6
All Rights Reserved Copyright 2006-2009 © PFU LIMITED