Furuno RP-250 - Manual (Page 40)

7. AIS OPERATION
34
7.4.3 Activating all sleeping AIS targets
1. Press the [AIS MENU] key to open the AIS menu.
2. Press the [7] key (ACTIVATE ALL TARGETS).
3. Press any menu key to close the menu.
7.5 Displaying Target Data
7.5.1 Basic target data
1. Place the cursor on an AIS target symbol.
2. Press the [AIS DATA] key to show the target’s basic data. The target is
marked as below.
Activated target selected for data display
VOYAGER
CALL SIGN 1436782 02
RNG
9.92NM
BRG 234.1 ° TRU
COG* 321.2 ° TRU
SOG# 21.1KT
CPA 2.8NM TCPA 23.5MIN
HDG 234 °TRU ROTR** 1.1° /MIN
Ship’s name
Call sign
Range from own ship to target
Bearing from own ship to target
Course over ground
Speed over ground
CPA, TCPA
Heading, ROT (Rate Of Turn)
Fusion target no.
* = CSE (course) when water tracking mode is selected at radar.
# = STW (speed thru water) when water tracking mode is selected at radar.
** = ROTR: right turn, ROTL: Left turn
Basic data display
3. Press any menu key to close the data display.
Note: You may also show basic data by pressing the [AIS MENU] key followed
by the [3] key (BASIC DATA). Basic data is hidden by the AIS1 menu;
close the AIS1 menu to show basic data.