Furuno RP-250 - Manual (Page 25)

4. WAYPOINTS, NAV LINE
19
4.3 Displaying Waypoints
A waypoint may be shown on the display as below.
4.3.1 Displaying waypoints
1. Press the [NAV MENU] and [2] keys to choose the WAYPOINT menu.
[WAY POINT]
1 [NAV INFORMATION(1)]
2 WPT MARK
OFF/ON
3 WPT
WPT 00
WPT 00
WPT 00
WPT 00
WPT 00
4
5
6
7 WPT DATA
VIDEO PLOTTER/NAVAID
8 ARRIVAL ALARM
OFF/ON
x.xxNM
WAYPOINT menu
2. Press the [2] key twice to choose WPT MARK ON and then press the
[ENTER] key.
3. Press the [3] key.
4. Enter waypoint number (01 to 98) in two digits and then press the [ENTER]
key. The latitude and longitude position of the waypoint appears on the
menu and the waypoint is displayed on the screen. Five waypoints may be
displayed.
5. Press the [NAV MENU] key to close the menu.
Note 1:
To display no waypoints, choose OFF at step 2 in above procedure.
Note 2: To clear all waypoints currently shown, enter 00 at step 4.
4.3.2 Displaying waypoints from a navigator
1. Press the [NAV MENU], [1], [0] and [0] keys to show the NAV
INFORMATION 3 menu.
2. For other than G-type radar, press the [4] key several times to choose
USED WPL WP and then press the [ENTER] key.
3. Press [1], [1], [1] and [2] keys to show the WAYPOINT menu.
4. Press the [7] key to choose NAVAID.
5. Press the [ENTER] key.
6. Press the [NAV MENU] key to close the menu.
Note:
Route data fed from a navigator is displayed waypoint by waypoint.