InFocus IN1026 Advanced 4200-Lumen WXGA 3LCD Projector - Manual (Page 95)

www.infocus.com
Appendix
95
• Make sure your projector is correctly connected to external equipment.
• Make sure all devices are plugged in an AC power source and have been
powered on.
• If your projector fails to project image of the connected computer, restart the
computer.
Note
Your projector employs high voltage power for operation. Do not open its casing.
If the problem persists, call your dealer or service centre. Along with model number
of your projector and a description to your problem.
Troubleshooting Solution
A password prompt
displays after power on
• You have set up the Logo PIN Code lock function.
Remote control does
not work
• Check the battery.
• Make sure there is no obstacles stand in between your
projector and the remote control.
• Make sure the remote control is not too far away from your
projector. The maximum operation range is 8m.
• Make sure the remote control and your projector are paired
with the same remote control codes.
• Disable the key lock of the remote control in the Setting
menu.
Light indicator turns
on or flashes
• Check status of your projector according to the light
indicator status.
"X" mark displays • Invalid operation, please operate your projector correctly.
Control panel does
not function
• Disable the key lock on control panel function in the Key
lock option of the Setting menu.
Cannot remove
the Logo Select
password, Key Lock,
and PIN Code lock
• Please call your dealer or service centre.