InFocus IN1026 Advanced 4200-Lumen WXGA 3LCD Projector - Manual (Page 48)

www.infocus.com
Display
48
The menu display on the lower
right corner of the screen.
Background display
Select this function can adjusts background
colour.
Press < MENU > button on the remote control
or on the top control panel to display the OSD
menu. Press  button to select the display
menu, then press or  button.
1. Press  button to select [ Background
display ] menu.
2. Press button.
3. Press
 button to select required item.
The entire projection area display
blue.
The entire projection area display
black.
System
System selection
The scanning system and auto computer
adjustment function will detect the signal
format. If a PC is selected as the input signal
source, your projector will detect and adapt to
its signal format automatically. The projected
image can be displayed without any setup
operation.
Your projector will display one of the following:
If your projector failed to
identify signals not shown in
the signals format table, the
“Auto” message will display in
the System Signal Format menu.
The Auto PC Adjusting function
will make necessary adjustment
to your projector to project valid
images. If images are displayed
incorrectly, adjust it manually.
No PC signals detected. Check
the connection between PC and
your projector.
Lower right
Blue
Black
Auto
-----
Display
Auto PC adj.
Fine sync
H position
V position
H.Size
Aspect Wide
Front
Upper left
Blue
Project way
Menu position
Background display
System
Background display menu
Note
This function will be invalid
once you select input signal as
USB display, Memory Viewer or
Network.
Note
Your projector may save data
generated by the Auto PC
Adjusting function.
Display
Auto PC adj.
Fine sync
H position
V position
H.Size
Aspect Wide
Front
Upper left
Blue
Project way
Menu position
Background display
System
System Signal Format menu
Note
The computer system menu will
be disabled if HDMI 1, HDMI 2,
Memory Viewer, Network, USB
Display have been selected.