InFocus IN1026 Advanced 4200-Lumen WXGA 3LCD Projector - Manual (Page 91)

www.infocus.com
Maintenance and cleaning
91
Follow steps below to replace the lamp:
1. Power off your projector and unplug the AC
power cord. Let it cool down for at least 45
minutes.
2. Open the lamp cover after removing screws
holding the cover.
3. Loose all 3 screws fixing the lamp. Remove
the lamp by holding its handle.
4. Replace with a new lamp and tighten all
3 screws. Make sure the lamp has been
installed correctly. Close the lamp cover
and tighten the screw.
5. Connect your projector to an AC power
source and power it on.
Note
Do not replace the lamp after it went dark as it may be broken. Always assume the
lamp of a ceiling mounted your projector is broken when replacing it. Stand beside
the lamp cover instead of below it. Remove the lamp cover gently. Small piece
of glass debris may fall out when opening the lamp cover. Consult with a doctor
immediately if there is any glass debris fell in your eyes or mouth.
Note
Let your projector cool for at least 45 minutes before opening the lamp cover, as
temperature within your projector is high.
Note
Replace the lamp with a new one of the same model just in case. Do not drop or
touch the lamp! It may break and lead to personal injuries.
Note
Always use original manufactures
lamps to ensure your projector
is no damaged and operates
according to design.
Lamp cover
Handle
Screw