InFocus IN1026 Advanced 4200-Lumen WXGA 3LCD Projector - Manual (Page 67)

www.infocus.com
Expand
67
Remaining time before
power off the lamp.
No signal
01 : 20
Power management
To reduce power consumption and maintain
life cycle of lamp, the power management
function will turn off the projection lamp if your
projector has no signals for a period of time.
1. Press  button to select [ Power
management ] menu.
2. Press button.
3. Press
 button to switch required item.
The Power light indicator flashes
green when the lamp is fully
cooled down. The lamp turns
on again if an input signal is
connected or any key (except
the power button ) on the
rear panel and remote control is
pressed during this period of time.
The projector shut down after the
lamp is fully cooled down.
Disable the power management
function.
Once the input signal is
interrupted and no keys has
been pressed for 30 seconds
afterwards, the “No signal”
message displays in the timer.
The timer counts down until the
lamp turns off. Press arrow key to
set up the timer in range of 1~30
minutes.
• Set up the interval from ready
mode change to standby (0 to 30
minutes) automatically. A setting
of zero minutes keeps your
projector from auto transition.
• Press the Power key to change
your projector from ready to
standby mode and any other key
to power it on.
Ready
Shut down
Off
Timer
Ready
countdown
Note
• Factory default:
Timer: 5 minutes;
Ready countdown mode: 5
minutes.
Network
...
Expand
Language
Auto setup
Keystone
Logo
Security
Power management
Filter counter
Test pattern
Factory default
Power management menu
Expand
Power management
5 Min
5 Min
Ready
Off
Timer
Ready countdown
Shut down