Quintum Technologies Tenor DX - Manual (Page 43)

3-8 P/N 480-0049-00-10
Chapter 3: Installation
Connect to Ethernet LAN
You can use these instructions for general connection purposes only. The Ethernet hub/switch manufacturer’s
documentation should provide specific instructions for connection to another device, such as the Tenor DX.
Only LAN 1 is available for use; LAN 2 is reserved for future use.
Figure 3-6 Connect to Ethernet Hub/Switch
1. Plug one end of the grey or white RJ-45 Ethernet cable into the port labeled LAN 1.
2. Plug the other end of the cable into one of the Ethernet hub/switch ports. If a custom cable or adapter is
required, see Chapter 2: Hardware Components for Ethernet RJ-45 10/100.
1 2 3 4 5 6 7 8
R
E
S
E
T D I A
G
CONSOLE POWER
ALERT
LAN 1 LAN 2
Line/Act
100
Line/Act
100
Data
Network
Ethernet Hub/Switch