Quintum Technologies Tenor DX - Manual (Page 101)

10-6 P/N 480-0049-00-10
Chapter 10: Using IVR
Configure IVR - Quick Start
For a Tenor DX to be used as part of the complete IVR system, and communicate effectively with the
RADIUS, you must configure basic options in the Tenor DX via Command Line Interface (CLI) for the fol-
lowing:
• Basic IVR Data
• RADIUS
Instructions for configuring basic IVR information via Command Line Interface (CLI) are described below.
For detailed information about all CLI commands available for IVR and detailed information about the com-
mand described below, see the Command Line Interface guide you received with the unit.
Basic IVR Data (via Trunk Group)
Configure basic IVR information as follows:
1. Access CLI.
2. Access the config-trunkcircuitroutinggroup-1# prompt.
3. Type set ivrtype 2 (sets the IVR type to pre-paid calling services).
4. Type set ivraccessnumber, followed by the telephone number used to access the IVR system (up to 14 dig-
its).
5. Type ivrcardlength 10 (10 is an example, the length of the calling card is numeric up to 20 digits).
6. Access the applicable config- trunkcircuitroutingroup - 1# prompt.
7. Set the ivrlanguage field to the applicable language: 0 (English), 1 (Persian), 2 (Mandarin), or 3 (French),
4 (Spanish), 5 (German), or 6 (Arabic).
RADIUS Server
Configure RADIUS data via config radius# prompt as follows:
1. Access CLI.
2. Access the config-radius-1# prompt.
3. Type set psipa, followed by the IP address for the primary RADIUS server (i.e., set psipa 208.22.234.34).
The “p” indicates the primary RADIUS server.
4. Type set ssipa followed by the IP address for the secondary RADIUS server (i.e., set ssipa
208.22.234.32). The “s” indicates the secondary RADIUS server.
5. Type sharedsecret (sharedsecret is similar to password), followed by the RADIUS key (up to 63 charac-
ters) (i.e., sharedsecret 454AJU).
6. Ensure accountingtype is configured. If this field is set to 0, no “stop accounting” messages will be sent.