Quintum Technologies Tenor DX - Manual (Page 18)

P/N 480-0049-00-10 1-9
Chapter 1: Overview
Figure 1-4 Trunk Circuit Call Routing
Intra-trunk Routing - “Hairpinning”. As a result of intra-trunk routing, incoming calls from a
particular Trunk Circuit are switched by Tenor DX to be routed back out the same trunk circuit rout-
ing group.
Figure 1-5 Intra-Trunk Routing
Data Network Calls. Calls coming from the data network can be routed to the Line Circuit or Trunk
Circuit spans. The Tenor will route calls based upon the dialed number. If the number is configured
as a local phone number, the call will be sent to a Line circuit for termination, otherwise the call is
considered a “Hop-Off call” and the Tenor sends it out through a Trunk Circuit span, typically con-
nected to the PSTN.
Line
Circuits
Ethernet
PSTN B
Trunk
Circuits
Trunk
Circuits
PSTN A
Ethernet
(IP Network)
Tenor CMS PBX VOIP Call
Circuit
Call
Circuit
Call
R
POWER
ALERT
R
E
S
E
T 1 2 3 4 5 6 7 8 Line/Act
100
Line/Act
100
LAN 1 LAN 2 CONSOLE D
I
A
G
Tenor DX
Line
Circuits
Ethernet
PSTN B
Trunk
Circuits
Trunk
Circuits
PSTN A
Ethernet
(IP Network)
Tenor CMS PBX VOIP Call
Circuit
Call
Circuit
Call
R
POWER
ALERT
R
E
S
E
T 1 2 3 4 5 6 7 8 Line/Act
100
Line/Act
100
LAN 1 LAN 2 CONSOLE D
I
A
G
Tenor DX