AGI Security SYS-16A901 User Manual - Manual (Page 73)

APPENDIX 3 PUSH VIDEO CONFIGURATION
67
A3.2 Configuration
Before configuring Push Video, make sure:
1. The DVR system is set up as described in “2. CONNECTION AND SETUP” at page 4.
2. The DVR is connected to Internet.
3. You’ve installed the app, EagleEyes, on your iPhone, iPad or Android mobile devices.
For details, please refer to “APPENDIX 4 MOBILE SURVEILLANCE VIA EAGLEEYES” at page 68.
Step1: Right click to show the main menu.
Go to (ADVANCED CONFIG.)  "NOTIFY” to enable “GUARD” to “ON”, and configure your alarm
sensor type (N.C. or N.O.).
ADVANCED CONFIG
CANERA PUSH VIDEO PUSH MESSAGE MESSAGE MAIL VIDEO MAIL
DETECTION GUARD ON
ALERT CH01 ALARM OFF / INTERNAL ALARM  CH1
NETWORK CH02 ALARM OFF  CH2
DISPLAY CH03 ALARM N.O.  office
RECORD CH04 ALARM OFF  CH4
DEVICES
DCCS
IVS
NOTIFY
EXIT
Step2: Open EagleEyes, and add this DVR to the EagleEyes address book.
Note: For more details about EagleEyes operation, please visit www.eagleeyescctv.com .
Step3: Enable Push Video as described below, and try to trigger your sensor to see if you can receive Push Video
successfully.