AGI Security SYS-16A901 User Manual - Manual (Page 42)

MAIN MENU
36
7) RECORD CONFIG
Click “SETUP” to enter the setting page individually for manual record, event record and timer record.
For details, please refer to “5.1.1 GENERAL” at page 19.
5.4.7 DEVICES
ADVANCED CONFIG
CAMERA CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11  
DETECTION DEVICE PTZ 
ALERT ID 00
NETWORK PROTOCOL NORMAL 
DISPLAY RATE 2400 
RECORD
DEVICES
DCCS
IVS
NOTIFY
EXIT
1) DEVICE
For the PTZ camera, select “PTZ”.
For a zoom lens control camera:
The DVR will detect it automatically and display its model number here.
To configure the parameters for a zoom lens control camera, please refer to “5.4.8 DCCS” at page 37. Different zoom lens control
cameras might have different parameter settings. For details, please refer to their own user manuals.
2) ID
Click the current value to set the ID number (0 ~ 255) for the connected PTZ camera if necessary.
Make sure the ID setting of the camera is the same as the setting here, or the DVR will not be able to control
the device.
Note: To know the default ID of the PTZ camera, please refer to its user manual.
3) PROTOCOL
Select NORMAL (our protocol), P-D (PELCO-D) or P-P (PELCO-P) protocol.
4) RATE
Select the baud rate for the connected PTZ camera (2400 / 4800 / 9600 / 19200 / 38400 / 57600 / 115200).
Make sure the baud rate setting of the camera is the same as the setting here, or the DVR will not be able to
control the device.
Note: To know the default baud rate of the PTZ camera, please refer to its user manual.