beautypg.com

Reprogrammable keys and commands, Figure 72. normal operating display, Figure 73. code entry display – Interlogix KTD-405 Series User Manual User Manual

Page 71: Figure 74. program soft keys display, Figure 75. keys that can be reprogrammed, Reprogrammable keys, And commands

background image

Appendix A

Sample configurations and charts

67

Reprogrammable keys and commands

From the supervisor programming mode you can reprogram any of the soft keys with any of the available
commands.

Note: Holding the seq key for three seconds returns you to the normal operating display, except on displays where esc is

required to exit.

To reprogram soft keys, do the following:

Figure 75. Keys that can be reprogrammed

1. Beginning at the normal operating display,

enter the supervisor programming mode by
pressing and holding the key.

Figure 72. Normal operating display

2. After the keypad beeps and the code entry

display appears (Figure 73), quickly enter
the access code for the supervisor menus by
pressing the 1-4-7-6-seq key sequence.
The display will automatically advance to
the next display.

Figure 73. Code entry display

3. Press the key (for NEXT) until the

PROGRAM SOFT KEYS display appears
(Figure 74). Press the + side of the zoom,
focus, or iris key.

Note: Use the plus side of any of these keys for YES and

the minus side of any of these keys for NO.

Figure 74. PROGRAM SOFT KEYS display

CAMERA 0

MONITOR 1

ENTER PROGRAMMING

CODE:

PROGRAM

SOFT

KEYS?

_

CAMERA 22

ZONE 32 PA

Recommended set

Complete set