Interlogix KTD-405 Series User Manual - Manual (Page 36)

KTD-405/KTD-405A/KTD-405-2D Controller Keypad
User Manual
32
6. The next display mentions zone hubs
(Figure 43). A hub is the main controlling
device in a zone. Hub choices are DVMRE
DUP, CALIBUR MMX, TRIPLEX MUX,
DUPLEX MUX, SIMPLEX MUX,
MATRIX SWCH, SYM DVR, and DVMRE
TRI.
Figure 43. Zone hub display
7. The next two menus are used to set the
system’s size to restrict the user from calling
up unused addresses. They also define the
maximum number of keystrokes used to
automatically select an address. For
example, if there are fewer than ten monitors
in the system, the keypad user can select
each monitor site with only one key press.
Note: Zone outputs and inputs depend on the hub you
selected in the previous menu.
Figure 44. Zone monitor outputs
8. Enter the number of monitor outputs you
have for this zone (1 to 32). Zone size
choices are 4, 9, 10, 16, 32, and 64,
depending on the hub (up to 64 for matrix
switchers, up to 32 for multiplexers, up to 20
for SymDVR’s, and up to 16 for all others).
Figure 45. Zone camera inputs
9. The following system access menus
(Figure 46) are used to restrict the keypad
from addressing specified sites in the system.
Note: If you are using MMX or Triplex without a VCR
attached through submacros, deny zone recorder
access.
The last menu in Figure 46 returns you to the
ENTER ZONE ADDRESS menu (Figure 40
on page 31).
Figure 46. Access restriction menus
10. From the ENTER ZONE ADDRESS menu
(Figure 47), you can program all zones.
When you have finished programming all
zones, pressing from the ENTER ZONE
ADDRESS menu displays the ZONE
ACCESS menu (Figure 47).
Figure 47. ZONE xx ACCESS menu
+ or – Enables you to allow or deny access for each zone.
Displays the next menu:.
ZONE 01 HUB:
DVMRE DUP
ZONE 01 MON.
OUTPUTS:
ZONE 01 CAM.
INPUTS: 16
ZONE 1 CAM 01 ACC?
YES
ZONE 1 MON 1 ACC?
YES
ZONE 01 RECORDER
ACC? YES
ZONE 01 ACCESS:YES
(+)=YES (-)=NO