Interlogix KTD-405 Series User Manual - Manual (Page 27)

Chapter 3
Programming
23
2. The keypad address screen is shown in Figure 17 on page 22. A keypad address is a number from 1 to
254 that distinguishes a keypad from other devices. This address is automatically assigned (starting at
99 and proceeding downward in value) when the keypad is first connected into the RS-485
communication line. You can assign higher addresses manually. The address doesn’t change unless
you assign a new address or the system configuration changes. Enter a new keypad address or press
to display the following menu (Figure 18).
Note: Entering an address that is already assigned displays a menu that reads ADDRESS ALREADY IN USE. Each Keypad
uses a RS485 device ID to communicate in the RS485 serial network.
3. The KB3 keypad uses an earlier version of
the communication protocol. In most cases
this menu setting will remain at the default
value of NO. However, if the KTD-405 you
are using in a system that needs to
communicate PTZ commands to a Calibur
CBR-KB3/J keypad or ProBridge, you may
need to select YES so that the KTD-405
communicates properly with these devices.
Figure 18. KB3 PTZ PROTOCOL display
4. Enabling remote programming allows you to
enter the 9-5-1-seq code for
programming remote devices in the system.
If disabled, a tone sounds when you enter the
9-5-1-seq
code, but not the menu.
Figure 19. ENTER REMOTE PRGMG display
5. Use the , , , or keys or move the
joystick to title the keypad (Figure 20).
or Moves from a space to A through Z, to
9 through 0.
or Moves from a space, to 0 through 9, to
Z through A.
or Moves the cursor right.
or  Moves the cursor left.
A keyboard title can be up to 14 characters.
Titles can include A through Z, 0 through 9,
and spaces.
Figure 20. KEYPAD TITLE display
KB3 PTZ PROTOCOL?
NO
ENABLE REMOTE
PRGMG? YES
KEYPAD
TITLE:( , ,
,
)