Entering programming modes, Figure 15. normal operating display, Figure 16. enter programming code menu – Interlogix KTD-405 Series User Manual User Manual
Page 25

Chapter 3
Programming
21
Entering programming modes
To enter programming mode, do the following:
3. Enter your programming code:
•
Supervisor:
Press 1-4-7-6-seq and see
•
User:
Press 5-7-9-seq and see
•
Remote device:
Press 9-5-1-seq and see
Note: These access codes can be changed by the installer or administrator. They will tell you the new codes if your are allowed
access to the menu. Menus time out after four minutes. Menus that were not implemented in this release are indicated by
two beeps and a message that reads NOT IMPLEMENTED.
1. When you provide power to the unit, the
normal operating display appears
(Figure 15).
Figure 15. Normal operating display
2. Press and hold the key until you hear a
tone and see the ENTER PROGRAMMING
CODE menu appears (Figure 16).
Note: The ENTER PROGRAMMING CODE menu times out
after five seconds.
Figure 16. ENTER PROGRAMMING CODE menu
CAMERA 0
MONITOR 1
ENTER PROGRAMMING
CODE: