Interlogix KTD-405 Series User Manual - Manual (Page 35)

Chapter 3
Programming
31
Zone menus
Remember that the addressing between domes and multiplexers is offset. When setting up and controlling your
cameras in zone mode, refer to
Receiver site addressing on page 65).
To program your keypad in zone mode, do the following:
1. Bring up the OPERATING MODE menu
(Figure 38).
Figure 38. OPERATING MODE menu
2. Select ZONE to displays the zone menu
(Figure 39). This menu enables you to
change the hub device label displayed on the
LCD during normal operation. Label choices
are ZONE, MPLX, DVMR, TERR, BLDG,
FLR, DEPT, STA, SITE, or AREA. ZONE is
the default label.
Figure 39. Zone menu
3. At the ENTER ZONE ADDRESS menu
(Figure 40), pressing takes you to the
ZONE xx ACCESS menu (Figure 47 on
page 32).
Figure 40. ENTER ZONE ADDRESS menu
4. Enter a two-digit zone address to display the
ZONE xx TITLE menu (Figure 41). Use the
, , , or keys or move the joystick to
title the zone.
or Moves from a space to A through Z, to
9 through 0.
or Moves from a space, to 0 through 9, to
Z through A.
or Moves the cursor right.
or  Moves the cursor left.
Figure 41. ZONE xx TITLE menu
Zone titles enable you to identify which zone is being addressed (Building 248, Headquarters, etc.). A
zone title can be up to 15 characters. Titles can include A through Z, 0 through 9, and spaces.
5. If you have reached the ZONE TITLE menu
through the SUPERVISOR menu and enter or
change the title, you have the option to send
the title to all keypads in the system
(Figure 42). This menu does not appear if
you entered with the USER menu code.
Figure 42. SEND TO ALL KEYPADS display
OPERATING MODE:
ZONE
LCD DISPLAY LABEL:
ZONE
ENTER ZONE ADDRESS:
01
ZONE 01 TITLE:
( , ,
,
)
SEND TO ALL
KEYPADS?