AltiGen MAXCS 7.0 Update 1 MultiVOIP Configuration - Manual (Page 9)

MAXCS 7.0 Update 1MultiVoIP Configuration Guide Page 9 of 27
Under the following conditions, the system administrator will need to check the Connect Voice Stream to
Server option:
• When the Voice Recording feature is used on the AltiGen IP phone (or the FXS extension behind
MVP410)
• When a supervisor wants to silently monitor, barge in to, or coach the extension
In these cases, the administrator needs to make sure the bandwidth between headquarters and the
branch office is sufficient.
Basic Configuration
The MVP410 has 4 FXS/FXO channels. Each channel can be configured as a SIP extension or SIP tie-trunk
channel to PSTN. It is possible to configure two channels as two SIP extensions and two channels as two
SIP trunking channels to PSTN.
SIP Extension Configuration
Before you configure SIP extensions, you must check that all of the requirements in the Requirements
section have been met.
Ethernet
MaxCS
IP Address
10.10.0.237
Ext 251
MVP 410
Ext 252
VPN/
Frame
Relay
Router
Router
IP Address
10.10.101.81
AltiGen IP phone
Ext 210
IPAddress
10.10.50.30
Ext 104
Figure 1: SIP Extension Configuration
This section shows steps for the following example configuration:
• The IP address of MaxCS at headquarters is 10.10.0.237
• MaxCS has one analog extension, extension 104
• In the remote site, the IP address of the AltiGen IP phone at extension 210 is 10.10.50.30
• The IP address of the MultiVoIP MVP 410 gateway is 10.10.101.81