AltiGen MAXCS 7.0 Update 1 MultiVOIP Configuration - Manual (Page 17)

MAXCS 7.0 Update 1MultiVoIP Configuration Guide Page 17 of 27
5. Log into the MultiVoIP tool.
6. Select Phone Book > Inbound Phone Book and add a new entry with the following parameters:
• Set Remove Prefix to 222
Important! You can pick any prefix, but once the prefix is selected, it cannot be used as an
extension number.
• Set Channel Number to Channel 3
7. Repeat the same settings for FXO port Channel 4. (Apply the settings only for channels
configured as FXO ports instead of FXS ports.)
8. Under Save Setup > Save & Reboot, click OK. Wait for the MVP410 to reboot itself.
Verification
1. Follow Figure 2, and attach a PSTN line 510252001 to FXO/FXS channel 3 behind the MVP
gateway.
Note: Attach the line to an FXS/FXO port instead of E&M port.
2. Pick up extension 104 (as illustrated in Figure 2) and dial “IP trunk access code” + “IP Dialing
Table Entry ID” + “222” + “14081231234” + “#”.
In this example, the number to dial is 8 1 222 14081231234#.
If “#” is not dialed, the call will still be sent out after a few seconds
Advanced Configuration
Before configuring these SIP-tie trunks, the requirements in the section Requirements must be met, and
the steps in the sections SIP-Tie Trunk Configuration for Incoming Calls from PSTN and SIP-tie Trunk
Configuration for Outgoing Calls to PSTN must be completed.
Analog extensions behind the MVP gateway are optional. If the analog extensions are required, complete
the steps in the section SIP Extension Configuration before you proceed.
In addition, make sure you already can make calls among phones, the MVP gateway, and MaxCS without
any problems.