AltiGen MAXCS 7.0 Update 1 MultiVOIP Configuration User Manual
Page 13
MAXCS 7.0 Update 1MultiVoIP Configuration Guide
Page 13 of 27
9.
Repeat the same process for extension 252 by adding a new entry where Remove Prefix is 252
and Channel Number is Channel 2.
10.
Under Save & Reboot, click OK. Wait for the MVP410 to reboot itself.
11.
Attach analog phone sets to the MVP410 system (FXO/FXS port).
12.
Make some test calls among ext 104, ext 251 and ext 252.
SIP-Tie Trunk Configuration for Incoming Calls from PSTN
Before you configure SIP-Tie trunks, check that all of the requirements in the
section on
page 3 have been met.
Analog extensions behind MVP410 are optional. If analog extensions are required, make sure you also
complete the steps provided in the section
Ethernet
MaxCS
IP Address
10.10.0.237
Ext 251
MVP 410
Ext 252
VPN/
Frame
Relay
Router
Router
IP Address
10.10.101.81
AltiGen IP phone
Ext 210
IPAddress
10.10.50.30
Ext 104
PSTN
Trunk Number
5102520001
5102520002
Tel 4081231234
Figure 2: Configure SIP-Tie Trunks
This section shows steps for the following example configuration:
•
The MaxCS IP address at headquarters is 10.10.0.237
•
MaxCS has one analog extension, extension 104
•
At the remote site, the IP address of AltiGen IP phone extension 210 is 10.10.50.30
•
The IP address of the MultiVoIP gateway is 10.10.101.81
Ext 251 and Ext 252 are optional; refer to
for those instructions.