AltiGen MAXCS 7.0 Update 1 MultiVOIP Configuration - Manual (Page 23)

MAXCS 7.0 Update 1MultiVoIP Configuration Guide Page 23 of 27
Verification
1. Follow Figure 3 . Use extension 104 to dial 15102520004. The call should go through the MVP
gateway.
2. Use extension 104 to dial 14081231234. The call should go through local trunks instead of the
gateway.
Outgoing Call to PSTN Using Extension Dialed Digit Translator
Before you start these procedures, make sure you have met the requirements in the section
Requirements on page 3, and perform the steps in the sections SIP-Tie Trunk Configuration for Incoming
Calls from PSTN and SIP-Tie Trunk Configuration for Outgoing Call to PSTN . The steps in the section
Outgoing Calls to PSTN using Out Call Routing are optional. Analog extensions behind MVP410 are
optional. If analog extensions are required, also perform the steps in the section SIP Extension
Configuration .
The MultiVoIP gateway is typically located in a remote branch office. When a user in the remote office
wants to make a trunk call, for voice quality purposes the remote user may always want the call go
through the MVP410 FXO ports. An administrator can configure “Extension Dialed Digit Translator” to
achieve this goal.
Please refer to Figure 3. When a remote user uses extension 251 or 210 to make a call to 15102520004,
MaxCS needs to translate the number to 8-1-222-2520004 (Refer to the section SIP-Tie Trunk
Configuration for Outgoing Calls to PSTN for details).
(Ext 251 and ext 252 are optional if you only use AltiGen IP phone 210.)
To configure this digit translation, follow these steps:
1. Log into MaxCS Administrator and select System > System Configuration > Number Plan.
2. In the Dialed Digit Translator panel, check the Enable check box and click Setup.
1. In the Dialed Digit Translator window, from the Select Digit Translator list select Extension Dialed
Digit Translator.
2. Create a new Extension group named Area Code 510.