Pulsafeeder Digital Glycol Feeder DGF2 - Manual (Page 8)

3
2. Installation
2.1 Assembly
™
If your DGF is shipped to you unassembled, perform the following: (If you ordered the
assembled version go to section 2.2 – Electrical Wiring.)
F AILURE TO FOLLOW THESE WARNINGS AND ASSEMBLY INSTRUCTIONS COULD RESULT
IN SERIOUS INJURY OR DEATH !
• Read all instructions carefully before assembly.
• Check all connections to ensure they are tight before applying pressure to the system.
• Wire in accordance to applicable electrical codes.
• Never subject components to full water immersion.
• Never attempt to move this system when the tank is full.
• DO NOT apply lateral force to the tank. The tank can tip spilling the contents.
• When filling the tank use care to prevent spillage or splashing on the wiring or tank cover.
• This system is designed for feeding Ethylene Glycol into pressurized closed loop systems.
• DO NOT run pumps dry.
• DO NOT exceed rated pressure of 80 psi.
DO NOT DEVIATE FROM THESE ASSEMBLY INSTRUCTIONS . Q UALIFIED CUSTOMER
SERVICE REPRESENTATIVES CAN BE REACHED AT THIS TOLL FREE NUMBER IF
ASSISTANCE IS NEEDED : 1 (800) 333-6677.
2.1.1 Tools Required For Assembly
• Phillips head screw driver.
• Adjustable wrench.