Pulsafeeder Digital Glycol Feeder DGF2 - Manual (Page 12)

7
2.1.4 Mounting The Tank
1. Turn the tank upside down and screw the plumbing stack assembly into the adapter attached
to the bottom of the tank. Tighten until snug plus 1/4 turn. Orient as shown in Figure 6 –
Tank Installation below.
2. Lift the tank, turning the open side up with the plumbing stack against your body.
3. Tip the top of the tank toward you and lower the tank onto the stand while feeding the
plumbing stack through the pump support and under the front cross bar between the pumps.
Figure 6 – Tank Installation
2.1.5