Calibration(s) not completed 5-2, Measurement calibration 5-1, Chapter 5 operations, measurement – Anritsu ME7840A User Manual
Page 63: Introduction -1, Operation, general -1, Measurement calibration -1, General -1, Calibration(s) completed -1, General operations, measurement
n C5, Hot S
22
¾ “Hots22_1.cal”
Step 5.
Select appropriate file “Open” (below).
Calibration(s) Not
Completed
Sometimes users may wish to run a measurement using default settings,
that is, without spending the time required to calibrate. The procedure
below gives instructions.
Step 1.
Click on “Tools,” and open “Check Communications to VNA.”
Step 2.
Verify the communications are correct.
Step 3.
Click on “Tools,” and open “Calibration File Options.”
Step 4.
Clear the text for all modules then select “Return.”
Step 5.
Press any measurement button on main menu and measure-
ment will be run using “PATS software” default values: Cali-
bration Off on MS462XC and MS462XC Default parameters
in place. The default values are shown below.
GENERAL
OPERATIONS, MEASUREMENT
5-2
ME 7840A OMM