Appendix a calibration specification files, Introduction a-1, File types a-1 – Anritsu ME7840A User Manual
Page 111: Open files a-1, Technical details a-1
Appendix A
Calibration Specification
Files
A-1
INTRODUCTION
This appendix describes the Calibration Specification Files that are used
to specify calibrations that are performed when accessing “Tools,” “Run
Calibration Procedures” in the PATS software. It lists file types, describes
how to open the files for edit, provides technical details of the files, and
shows typical file listings.
A-2
FILE TYPES
There are four files that specify calibrations for (A) Power Level; (B) Hot
S
22
; and (C) S-Parameters; (D) Cal File Setup for Receiver Cal, IMD,
Power Sweep, and Harmonics.
A-3
OPEN FILES
To view or edit the specification files, highlight the filename and right
click the mouse to display a dialog box. Left click on “Properties” then on
“Open” to open the file in Notepad.
A-4
TECHNICAL
DETAILS
Technical details on how to construct and edit Calibration Specification
Files are provided in Table A-1.
ME7840A OMM
A-1