Analog Way Axion2 - Manual (Page 41)

If you are working with an 8x4 matrix (8 in, 4 out), you will need
to define the links between the slave device and the matrix for the
Axion2 to route signals properly.
1/ Press Edit Inputs to open the Inputs page, then select Matrix
Mapping.
2/ Select Input 1 from the dropdown menu, and in the Linked to
Matrix dropdown menu, select your matrix.
3/ In the Matrix Output dropdown menu, select your output
connection.
4/ Repeat steps for Inputs #2 to #4 (matrix outputs #2 to #4).
5/ Press the [OK] button to return to the Screen Setup page.
So far, you have set a series of links between your slave device and
a matrix, but you are still limited to the slave device’s input switching
(source #1 to slave device input #1, source #2 to slave device input
#2 and so on). To change this, proceed as follows:
1/ Press Edit Sources to open the Source Setup page, and set
the source Type to Live.
2/ In the Main/Preview section, press [SOURCE] button 1, and
press Edit if you wish to rename it.
3/ In the Linked to Matrix dropdown menu, choose the matrix
entered previously, then the type of signal coming from the
matrix.
4/ In the Matrix Input dropdown menu, select the Matrix Input
number you like.
5/ Repeat steps for sources #2 to #8.
6/ Press the [OK] button to return to the Screen Setup page.
6-2. MATRIX SETUP EXAMPLE
39