Analog Way Axion2 - Manual (Page 35)

33
The sequence mode will allow you to perform a complete show thanks to your presets already saved.
Press the [SEQ MODE] button to have access to the sequence menu.
There you can add preset one after the other in order to make a string of preset. Every presets can be set
upped in term of duration using the timing bar on the bottom right. Follow the marker to know where your step
will be inserted.
At any moment you can delete one preset in the sequence using the delete step button. The delete operation
will move every steps located on the right side of the marker, one step to the left.
The [CLEAR] button will only delete step information on selected screens without moving the string to the left.
(It will move the string to the left too if the step is empty for every screens).
There are 2 ways to create the string sequence, by inserting new preset, or by overwriting presets.
The 2 choices are available by pressing MODE.
* TIP * : - Impossible to add an empty preset in a sequence.
- Long press on the [<] or [>] button: Shifting at the start or the end of the sequence.
- Short press on the [<] or [>] button: Moving step by step in the sequence.
Located in the transition area, the screen filter is composed by 6 buttons, each one linked to one of the 6 screens.
It acts like the last filter before the take (sending your preview into your main). When a preset is composed by
several screens, all your screens will be taken. The Screen filter feature allows you to decide for every preset
which screen will be changed or not.
It’s a very simple use, just select/unselect the desired screen to allow or not the transition to the next preset.
The other function of this feature is to save/load presets only for the selected screens of
the transition group. When you want to save/load a preset only for particular screen, first
select/unselect the chosen screens in the transition section then save/load your preset
using the long press on the [PRESET] button.
Working with the Screen Filter
The Axion2 can save up to 9 sequences thanks to the [SAVE TO SEQ] button. Use the [LOAD FROM SEQ]
button to load an already saved sequence.
Once your sequence is saved, you can play it by pressing the [TAKE] button, or in an auto-take mode. To
use the sequence in that way, just check the auto-take box. In addition, the loop box will allow you to repeat
automatically the sequence from the step n°1 when you reach the last step.
Working with a sequence